Boiler

The necessity and significance of boiler cleaning: boiler after a long run, the inevitable emergence of scale, corrosion problems, these problems are due to the generation of scale, so that the heat transfer deterioration, resulting in reduced efficacy boiler. It is difficult to achieve nominal evaporation; and since the heat transfer is deteriorated, such that the metal overheating, under pressure boiler, furnace tube bulge occurs even explode; poor thermal conductivity, so that the fuel consumption is increased, increased operating costs, boiler shortened life expectancy. Therefore, the boiler scale, should take the necessary cleaning methods.

Blue Sky Battle horn started, our country constantly walking on the green road. Reduce atmospheric emissions of nitrogen oxides, improve air quality, but also the people a blue sky, the industry has invested in the construction of environmental protection go, Guizhou Baiyun Quan Lake Hotel is no exception. As we all know, fast boiler R & D in the field of clean fuel boiler never stopped, through market research and screening, Guizhou Baiyun Quan Lake Hotel in October 2017 signed a low-nitrogen Thalia T5 series vacuum hot water and fast boiler boiler for hot water supply and heating the hotel.

Maintenance method daily operation of boilers in daily use and so prone to fouling, if not handled properly accidents may occur, in order to make the normal operation of the boiler, the need for routine maintenance as follows runtime: 1, each class should check grate reducer, the tap head and gear lubricants induced draft fan in the bearing housing is held within the allowable range, light fuel should be promptly, permeability should be promptly removed. 2, at all events are required to add oil. 3, all oil cups are filled with oil. 4. The grate shall tighten or loosen, four bolts on the housing shall relax the base beforehand. 5, when the induced draft fan to severe vibration should stop checks, generally based internal impeller wear or fouling caused by severe and should be replaced. 6, the gland gasket lower portion of the slag, the grout leakage found, should be kept pressed against the gasket, gasket replacement or temporary parking, stop leakage, and check if grout leakage into the bearing, should open cleaning. 7, the bottom of the boiler water is not ground plane, to prevent wet etching of the base. These are the daily operation and maintenance of boiler, and I hope you can learn knowledge, good maintenance of the boiler in order to extend its service life, there is hope for your help.

2. What is the condensing boiler?

Condensing boilers achieve higher efficiencies by condensing water vapor contained in flue gases. When fuel is combusted in a boiler, approximately 90% of the energy contained in the fuel is converted into sensible heat (heat that causes a change in temperature) and approximately 10% is converted into latent heat (heat involved in phase change of a material). This latent heat is stored in the water vapor that is a byproduct of the combustion process.