Boiler

This is our first collaboration with fast 10 ton capacity coal boiler, professional and caring service fast boiler's impressed us. From pre-sales advice to after-sales guidance, every step is very careful and thoughtful. They provide hot water boiler performance is also very good, and effectively improve the level of our heating units. --customer feedback

Development condensing gas 10 ton capacity coal boilers What's the point: To reduce fog and haze, clean air environment, working across the country are carrying coal to gas boilers. The advantage of using gas-fired boiler coal-fired boiler, many alternative, the first gas itself clean, dust does not occur during transport and during use, and gas generated by the combustion of sulfur dioxide and nitrogen oxides are also less than in coal-fired boilers. The use of gas-fired boiler itself is in line with the needs of environmental protection, but the cost of natural gas than coal, so we must ensure that the use of gas-fired boiler thermal efficiency of boilers, condensing gas boiler was born!

The heat exchange surface of Fangkuai 10 ton capacity coal boiler is reformed reasonably: 1. The horizontal boiler is removed from the furnace arch of the original furnace, and the coal bed is covered with insulation layer and refractory brick, which is transformed into the secondary radiation surface. Vertical boilers can build radiation reactors at the bottom of the furnace and install radiation arches on the upper part of the tank. 2, control the leakage air volume of furnace and flue. It is necessary to seal the boiler's observation hole, to seal the boiler's air duct and flue, especially when the air leakage rate of brick air duct and flue is large, after changing to burning gas, it is necessary to carry on the sealing treatment, preferably to change to the metal flue. When multiple boilers share a total flue, each boiler Breakers should be installed on the flue to prevent flue gas and residual gas from the purging process from flowing into the boiler furnace that has ceased to operate. Reasonable selection of burners for Fangkuai boilers: 1. Under rated gas supply pressure, the thermal load of the burners must meet the requirements of the boilers. Combustion is complete, excess air coefficient is low, combustion temperature is high, combustion noise is small, furnace flame fullness is good, flame radiation ability is strong. 2, the load regulation ratio meets the requirements of boiler operation, and the excess air coefficient can be adjusted. 3, can realize the boiler safety technical supervision regulations issued by the Ministry of Labor automatic control project.

Chemical plant 10 ton capacity coal boiler combustion efficiency improvement measures which are not high chemical plant boiler combustion efficiency is not high improvement measures what? The low-temperature exhaust gas boiler combustion efficiency test, a higher excess air ratio, suggestions for improvement higher problems: 1, the excess air ratio due to lower general, industrial boilers was 1.4. Due to the different internal structure of each of the boilers, excess air coefficient can be adjusted according to the actual operation, there are sufficient coke burn time in the boiler. Additionally, secondary air may be suitably provided, coke sufficient oxygen for complete combustion, reducing the incomplete loss of solids. 2, due to lower exhaust gas temperature of the boiler exhaust gas temperature account for a large proportion of the boiler heat loss, so the loss of the boiler must be minimized. In one aspect, the dew point should be to prevent corrosion; the other hand, the exhaust gas temperature is not so high. 3, to improve the uniform distribution of air to the boiler furnace combustion efficiency, so as not to cause incomplete combustion of the coal formation dead. As the pilot were grate boiler, the moving speed of the chain should be controlled within a reasonable range of coal on the grate have enough time to complete combustion, but not too long so as not to waste grate. In addition, high-volatile coal, the coal should be possible to improve the quality, to shorten the combustion time, reduce the loss of solids of incomplete combustion.